Patton CopperLink CL1101 PoE Extender over Twisted Pair or Coax, up to 3,300 Feet

Patton CopperLink CL1101 Power over Ethernet (PoE) Extender, 3,000' (1000 m) Distance

Patton Electronics’ Copperlink CL1101 family of Power over Ethernet (PoE) extenders provide data communication and power from a Fast Ethernet connection across exiting twisted pair(s) or coax cable runs. The CL1101 enables Ethernet connectivity over previously installed copper cables such as 2-wire 24-AWG twisted-pair, Cat 3, Cat 5e/6/7, or coaxial. The solution breathes new life into circuits deployed for legacy non-IP applications like RS-232/422/485 controls, alarms, CCTV, analog phones, and intercom speakers. Once a CL1101 pair of extenders are installed, you can quickly connect remote wireless access points (WAPs), IP cameras, IP telephones, IP door stations, HVAC controls, LED lighting, and other powered devices (PD) devices with no additional overhead cost. With an extended reach up to 3,300 feet, the CL1101 kit allows you to locate IP terminal equipment where you need it.

The CL1101 requires a Local and Remote unit at each end of a cable run. The Local model is typically located near the central network and powered by an AC to DC power adapter. The Remote unit is usually located on the network edge away from other devices. It may be powered from the PoE line. The pair includes Transparent LAN Bridging which passes higher layer industrial protocols such as tagged and untagged 802.1Q VLAN packets, BACnetIP, EtherCAT, and Modbus TCP. The bridge is fully transparent to WMV, MPEG-4, and MJPEG video compression schemes. PoE PowerPlus technology delivers power to the remote CopperLink extender and PDs connected to it. No power is required at the remote location.

Key Features

• Extends Ethernet distance over 3,300 feet (1005 meters) using twisted pair or coax
• 2 ports –network interface and line interface
• 1 Fast Ethernet (10/100TX) port with auto-sensing, full or half-duplex
• Accepts 2-wire 24-AWG twisted-pair, Cat 3, Cat 5e/6/7, or coaxial cable
• Choose RJ45 or BNC connectors (line interface)
• Local and Remote units required, one at each end of a cable run
• Delivers PoE to the remote CopperLink extender and powered device
• Transparent LAN bridging passes higher layer industrial Ethernet protocols
• Plug and Play – no setup required for operation
• Overvoltage protection on the Line and Ethernet ports

Configurations

CL1101/R/PAFA/BNC/E, PoE Remote extender, BNC connector, line-powered
CL1101/R/PAFA/RJ45/E, Same as above with RJ45 connector

CL1101/L/P/BNC/EUI, PoE Local extender with BNC connector, 100-240 VAC
CL1101/L/P/RJ45/EUI, Same as above with RJ45 connector

CL1101/PAFA/BNC/EUI-2PK, PoE extender pair with Local and Remote units and BNC connectors, AC Adapter 100-240 VAC
CL1101/PAFA/RJ45/EUI-2PK, Same as above with RJ45 connectors